RS01RP Super Active RFID Receiver Module I


 RS01RP Super Active RFID Receiver Module I ( Dimensions, 6 cm X 8 cm X 3 cm )

This is a low cost active RFID receiver (can read our active rfid modules only) with RS232 interface to connect to a host directly. This can also be used to drive some other circuitry via IO0 and IO1. A 9 to 12V DC supply is required to power the unit, which has a current consumption of less than 200 mA. A 9VDC/300 mA (2.1 mm center positive) plug jack will do fine. The on board relay has 28VDC 12A rating which is sufficient to switch on/off any external circuit.

Specifications,  RS01RP Super Active RFID receiver module I

Supply Voltage 9V to 12 VDC
Supply Current < 200mA
Operating Temperature 0 - 50C
Operating Frequency 315 Mhz
Build-in Watchdog Yes. 2.3 seconds
SERIAL PORT ( RS232)  
Type RS232,  9600 Baud, 8 bit words,1 stop bit,1 start bit, no parity

More Specification

Command Set

Pricing,  RS01RP Super Active RFID receiver module I

Description $US
RS01RP $44.95

 

Application,  RS01RP Super Active RFID receiver module I

Since this is an active RFID device, you don’t need to touch the receiver to activate the on board relay. This is very usefully for disability or elderly peoples who are using automatic devices such as electric door. A wheel chair installed with our transmitter can open an electric door when the wheel chair is within 8 meters from the door.

Visit our eBay Store

We can provide 433 MHz version on request. Please send your request to EnochChan01@gmail.com

Home