RF2315R
Active RFID Dual Receiver Module with RSSI
RF2315R Active RFID Dual Receiver
Module with RSSI ( Dimensions,
8cm X 6.cm )
The RF2315R active RFID receiver module receives
data sent from RF8315T modules. The module will report the RSSI values of
both on board receivers through serial port. There are 2 SMA connector for
directional antenna connection. You can use the RSSI values to determine
where the object is moving from.
Key Benefits, RF2315R Active RFID
Dual receiver module
with RSSI
- Plug and play. No need to send command to control
the receiver
- Can read all our Active RFID trasnitters
- 2 RSSI data will be reported that can be used to
determine where the object is moving from.
- There is a RS232 TTL output for direct connect
your other MCU or other circuit.
- I2C ready (Need to be customised according your
specification)
- Superheterodyne design for maximum stability
- Reverse power input protection
Specifications, RF2315R
Active RFID dual receiver module with RSSI
| Supply Voltage |
9VDC to 12VDC |
| Supply Current |
10mA Typical |
| Operating Temperature |
0 - 50C |
| Operating Frequency |
315 Mhz (433 Mhz is
also available) |
| Data Output |
(4 characters ID,
RSSIA,RSSIB) |
| Capacity |
40 ID at the same time |
| Build-in Watchdog |
Yes. 2.3 seconds |
| SERIAL PORT ( RS232) |
|
| Type |
RS232, 19200 Baud, 8 bit words,1
stop bit,1 start bit, no parity |
Pricing, RF2315R Active RFID
dual receiver module with RSSI
| Description |
$US |
| RF2315R (directional
antenna is not included. We will supply 2 straight wire as an antenna
that match our receivers and you need to solder by yourselves) |
$69.95 |
|